2008 Acura TL Owner's Manual - Page 303

Main Menu Table Of Contents Lights 3. Remove the electrical connector from the bulb by pushing on the tab and pulling the connector down. 4. Remove the bulb by turning it about one-quarter turn counterclockwise. 5. Insert the new bulb into the hole, and turn it one-quarter turn clockwise to lock it in place. 6. Push the electrical connector back onto the bulb. Make sure it is on all the way. Halogen bulbs get very hot when lit. Oil, perspiration, or a scratch on the glass can cause the bulb to overheat and shatter. 2. Use a flat-tipped screwdriver to remove the holding clips from the edge of the inner fender cover, and pull the inner fender cover back. 7. Turn on the fog lights to test the new bulb. 8. Push the inner fender cover in place. Install the holding clips, and lock them in place by pushing on their center. Replacing the Rear Turn Signal Bulb (in Fenders) 1. Open the trunk. Using a small screwdriver, pop up the pin in the center of the fastener, then remove the fastener. Unscrew and remove the cargo net hook from the fender. Pull back the trunk lining. 2. Remove the socket by turning it one-quarter turn counterclockwise. 300 2008 TL