2007 BMW 6 Series Owner's Manual - Page 115

Alternating-code hand-held transmitters To program the integrated universal remote control, consult the operating instructions for the equipment to be set. You will find information there on the possibilities for synchronization. When programming hand-held transmitters that employ an alternating code, please observe the following supplementary instructions: Programming will be easier with the aid of a second person.< 1. Park your vehicle within the range of the remote-controlled equipment. 2. Program the integrated universal remote control as described above in Fixed-code hand-held transmitters. 3. Locate the button on the receiver of the device to be set, e.g. on the drive unit. 4. Press the button on the receiver of the equipment to be set. After step 4, you have approx. 30 seconds for step 5. 5. Press the programmed memory button 1 of the integrated universal remote control three times. The corresponding memory button 1 is now programmed with the signal of the original hand-held transmitter. If you have any additional questions, please contact your BMW center.< 113 Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG Press the button. The glove compartment opens automatically and the lamps come on. To prevent injury in the event of an accident while the vehicle is being driven, close the glove compartment immediately after use.< Closing Fold the cover up. Rechargeable flashlight* The flashlight is located on the left side of the glove compartment. The flashlight can remain there continuously. Remove the flashlight from the socket when needed. Reference Mobility Communications Entertainment Navigation Driving tips If the device fails to function even after repeated programming, check whether the original hand-held transmitter uses an alternating-code system. To do so, either read the instructions for the original hand-held transmitter or hold down the programmed memory button 1 of the integrated universal remote control. If the LED 2 on the integrated universal remote control flashes rapidly for a short time and then remains lit for approx. 2 seconds, this indicates that the original hand-held transmitter uses an alternating-code system. In the case of an alternating-code system, program the memory buttons 1 as described at Alternating-code hand-held transmitters.< Deleting stored programs Press the left and right-hand memory button 1 for approx. 20 seconds until the LED 2 flashes. All stored programs are deleted. Programs cannot be deleted individually. Opening Controls Glove compartment At a glance