2007 BMW 6 Series Owner's Manual - Page 221
2007 BMW 6 Series Manual
Page 221 highlights
1. Fold open the cover of the BMW jumpstarting terminal. To do so, pull the tab. wait a few minutes before another attempt in order to allow the discharged battery to recharge. 3. Let the engines run for a few minutes. 4. Disconnect the jumper cables by reversing the connection sequence. Never use spray fluids to start the engine.< Observe applicable laws and regulations for tow-starting and towing.< Do not transport any passengers other than the driver in a vehicle that is being towed.< 3. Attach the second end of the cable to the positive terminal of the battery or to a jumpstarting terminal of the vehicle to be started. 4. Attach one end of the jumper cable minus/- to the negative terminal of the battery or to an engine or body ground of the vehicle providing assistance. Your BMW has a special nut as body ground or negative terminal. Only use the tow fitting that comes with the vehicle and screw it in as far as possible. Use the tow fitting for towing only on roads. Avoid lateral loading of the tow fitting, e.g. do not lift the vehicle by the tow fitting. Otherwise, the tow fitting and vehicle can be damaged.< Access to screw thread 5. Attach the second end of the cable to the negative terminal of the battery or to the engine or body ground of the vehicle to be started. Press the arrow symbol on the cover in the bumper. Front Starting engine 1. Start the engine on the assisting vehicle and allow it to run at idle for several minutes at slightly increased speed. 2. Start the engine on the other vehicle in the usual way. If the first starting attempt is not successful, 219 Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG Reference Mobility Communications Entertainment The threaded tow fitting is stored in the tool kit mounted on the inside of the luggage compartment under the floor mat, refer to page 212, and should always remain in the vehicle. It can be screwed in at the front or rear of the BMW. Navigation Using tow fitting Driving tips 2. Attach one end of the jumper cable plus/+ to the positive terminal of the battery or a jump-starting terminal of the vehicle providing assistance. Tow-starting and towing Controls Check the battery and recharge if necessary. At a glance