2007 BMW 6 Series Owner's Manual - Page 93
2007 BMW 6 Series Manual
Page 93 highlights
2. Check the air pressure in all four tires at the next opportunity. If the tire inflation pressure in all four tires is correct, the Flat Tire Monitor may not have been initialized. The system must then be initialized.< 3. In the event of complete tire pressure loss, 0 psi/0 kPa, you can estimate the possible distance for continued driving on run-flat tires, based on the following guide values: > With low load: 1 to 2 persons without luggage: approx. 155 miles/250 km. > With medium load: 2 persons, luggage compartment full, or 4 persons without luggage: approx. 94 miles/150 km. > With full load: 4 persons, luggage compartment full: approx. 30 miles/50 km. Drive reservedly and do not exceed a speed of 50 mph/80 km/h. In the event of pressure loss, vehicle handling changes. This includes reduced tracking stability in braking, extended braking distances and altered natural steering characteristics. If unusual vibrations or loud noises occur while the vehicle is being driven, this can indicate final failure of the damaged tire. Reduce speed and stop at a suitable location as soon as possible; otherwise, pieces of the tire could become detached and cause an accident. Do not continue driving, but instead contact your BMW center.< TPM Tire Pressure Monitor* The concept TPM checks the tire inflation pressure in the four mounted tires. The system reports when the tire inflation pressure has dropped considerably in one or several tires. Functional requirement In order to assure the reliable reporting of a flat tire, the system must have been reset with the correct tire inflation pressure. Always use wheels with TPM electronics, otherwise fault-free operation of the system is not ensured. Reset the system again after each correction of the tire inflation pressure and after every tire or wheel change.< TPM cannot announce sudden serious tire damage caused by external influences.< The system does not function properly if it has not been reset, e.g. a flat tire is reported despite correct tire inflation pressures. The system is inactive and cannot display a flat tire if a wheel has been mounted without TPM electronics, or if TPM is temporarily interfered with by other systems or devices which use the same radio frequency. Status display on Control Display The tire and system status is indicated by the color of the tires. TPM takes the fact that the tire pressure changes during driving into account. A correction is only required if requested by TPM with the color. Green The tire pressure matches the learned set state. "TPM active" is displayed on the Control Display. 91 Online Edition for Part no. 01 41 0 013 312 - © 02/07 BMW AG Reference Mobility Communications Entertainment Navigation System limits Driving tips Controls At a glance