1997 Buick Park Avenue Owner's Manual - Page 127

To program a garage door opener with the rolling code feature, dothe following: 1. Program your hand-held transmitter to the universal transmitter by following the steps provided under "Programming the Transmitter" earlier. You may now use either the universal transmitter or the hand-held transmitter to open your garage door. If you still have difficulty in programming and require assistance, please call your Buick dealer. Erasing Channels To erase all three programmed channels, hold down the two outside buttons until the amber light begins to flash. Individual channels cannot be erased, but can be reprogrammed using the procedure for programming the transmitter explained earlier. 2. Remove the cover panel from the garage door opener receiver. It is located near the garage door opener motor. 3. Locate the training button on the garage door opener receiver. The exact location and color will vary among brands. 4. Press the training button on the garage door opener Accessories Accessories for your universal transmitter are available from the manufacturer of the unit. If you would like additional information, please call 1-800-355-3515. receiver for oneto two seconds. 5. Return to your vehicle and press the programmed button on the universal transmitter until the amber light flashes rapidly (about two seconds). 6. Release the button, then press it again to confirm it was programmed to the garage door opener receiver. 2-67