2000 Buick LeSabre Owner's Manual - Page 63

yellowblue Vehicles are delivered programmed in Mode 3. Use the following procedure to change modes: 1. Close all the doors and turn the ignition on. Keep all doors closed throughout this procedure. 2. Press and hold LOCK on the driver's power door lock switch throughout this procedure. All the doors will lock. 3. Press the button with the lock symbol on the remote keyless entry transmitter. The automatic door locks will remain in the current mode. 4. Press the button with the lock symbol on the transmitter again. Each time this button is pressed, the mode will advance by one, going from 3 to 0 to 1, etc. Note: The door locks will cycle according to the mode entered while customizing the memory door locks. (Mode "0" has no feedback.) 5. Release the power door lock switch. The automatic door locks will remain in the most recent mode selected. This procedure only changes the mode for the transmitter used to change this setting. The procedure will need to be repeated for the second transmitter. If your vehicle is equipped with the Driver Information Center (DIC), you must program this feature through the DIC. See "Driver Information Center" in the Index. Delayed Locking This feature lets the driver delay the actual locking of the vehicle. When the driver's power door lock switch or remote keyless entry lock button is pressed with the key removed from the ignition, and the driver's door open, a chime will sound three times to signal that delayed locking system is active. When all doors have been closed, the doors will lock automatically after five seconds. If any door is opened before this, the five-second timer will reset itself once all the doors have been closed again. Pressing the driver's door lock switch or remote keyless entry transmitter button again will override this feature. Pressing the passenger's door lock switch will also override this feature. 2-6