2003 Buick LeSabre Owner's Manual - Page 121

To recall your memory positions, your vehicle must be in PARK (P). Push andrelease the MEMORY button corresponding to the desired driving position. The seat and mirrors will move to the position previously stored for the identified driver. You will hear one beep. To store the exit position for an easy exit, use the following procedure: 1. First identify the DRIVER # by pressing the MEMORY button 1 or 2 or by pressing the unlock button on the transmitter. 2. Adjust the driver's seat to the desired exit position. To recall the exit position, your vehicle must be in PARK (P). Push and release the EXIT button and the seat will move to the exit position previously stored for the current identified driver. You will hear one beep. If an exit position has not been stored for the current identified driver, the seat will move all the way back. To stop recall movement of the seat at any time, press the driver's power seat control located on the outboard side of the front seat. Mirrors and lumbar positions will not be stored or recalled for the exit position. 3. Press and hold the EXIT button for longer than three seconds. You will hear two beeps confirming that the seat exit position has been entered into memory. To set the exit position for a second driver, follow the previous steps, but start by pressing the unlock button on the transmitter that displays the other DRIVER # on the DIC. Be sure to use the MEMORY button which corresponds to the DRIVER # identified by the other transmitter. If you would like your stored driving or exit position to be recalled when unlocking your vehicle with the transmitter, see DlC Vehicle Personalization on page 3-51. 2-50