2003 Buick Regal Owner's Manual - Page 90

REVERSE (R): Use this gear to back up. Nofice: Shifting to REVERSE (R) while your vehicle is moving forward could damage your transaxle. Shift to REVERSE (R) only after your vehicle i stopped. s To rock your vehicle back and forth to get out of snow, ice or sand without damaging your transaxle, see If You Are Stuck: In Sand, Mud, Ice or Snow on page 4-30. NEUTRAL (N): In this position, your engine doesn't connect with the wheels. To restart when you're already moving, use NEUTRAL (N) only. Also, use NEUTRAL f h ' \ when your v e W e is being towed. Notice: Damage to your transaxle caused by shifting into a drive gear with the engine racing isn't covered by your warranty. This position is for AUTOMATIC OVERDRIVE normal driving. If you need more power for passing, and you're: Going less than 35 mph (55 km/h), push your accelerator pedal about halfway down. Going about 35 mph (55 km/h) or more, push the accelerator pedal all the way down. You'll shift down to the next gear and have more power. (a): Shifting into a drivegear while your engine is "racing" (running at high speed) is dangerous. Unless your foot is firmly on the brake pedal, your vehicle could move very rapidly. You could lose control andhit people or objects. Don't shift into a drivegear while your engine is racing. Notices If your vehicle seems to start up rather slowly, or if it seems not to shift gears as you go faster, something may be wrong with a transaxle system sensor. If you drive very far that way, your vehicle can be damaged. So, if this happens, have your vehicle serviced right away. Until then, you can use SECOND (2) when you are driving less than 35 mph (55 km/h) and AUTOMATIC OVERDRIVE (D) for higher speeds. THIRD ( ) This position is also used for normal driving, 3: but it offers more power and lower fuel economy than AUTOMATIC OVERDRIVE (@ ). 2-23