2005 Buick LeSabre Owner's Manual - Page 273

7. Replace the 3800 Series II V6 engine cover shield. 7.1. Remove the oil fill tube, with cap attached, from the valve cover. 7.2. Insert the catch tab on the cover shield under the bracket on the engine. 7.3. Place the hole in the cover shield over the hole in the valve cover. Install oil fill tube and cap by twisting clockwise. 7.4. If you have the supercharged engine, install the nut in the center of the cover shield. 8. Then fill the coolant recovery tank to the FULL COLD mark. 10. Start the engine and let it run until you can feel the upper radiator hose getting hot. Watch out for the engine cooling fans. 11. By this time, the coolant level inside the radiator filler neck may be lower. If the level is lower, add more of the proper DEX-COOL® coolant mixture through the filler neck until the level reaches the base of the filler neck. 9. Put the cap back on the coolant recovery tank, but leave the radiator pressure cap off. 12. Then replace the pressure cap. At any time during this procedure if coolant begins to flow out of the filler neck, reinstall the pressure cap. Be sure the arrow on the pressure cap lines up properly. 5-33