2010 Buick Enclave Owner's Manual - Page 62

3-12 Seats and Restraints To return the seatback to the seating position: 1. Raise the seatback into place by using the pullstrap from the rear of the vehicle, or by pushing it into place from inside the vehicle. 2. The headrest must be locked into place before sitting in the seat. { WARNING A safety belt that is improperly routed, not properly attached, or twisted will not provide the protection needed in a crash. The person wearing the belt could be seriously injured. After raising the rear seatback, always check to be sure that the safety belts are properly routed and attached, and are not twisted. 4. Reconnect the center safety belt mini-latch to the mini-buckle. Do not let it twist. 5. Pull on the safety belt to be sure the mini-latch is secure. Notice: Folding a rear seat with the safety belts still fastened may cause damage to the seat or the safety belts. Always unbuckle the safety belts and return them to their normal stowed position before folding a rear seat. 3. Fold the seatback down. See "Folding the Seatback" earlier in this section. 4. Remove the rear bolts located on the floor on each side of the seat. 5. Remove the seat by tilting it slightly upward, and then pulling it out of the rear of the vehicle in one motion. 6. Replace the bolts in the floor holes for storage. { WARNING If either seatback is not locked, it could move forward in a sudden stop or crash. That could cause injury to the person sitting there. Always push and pull on the seatbacks to be sure they are locked. 3. Push and pull on the seatback to make sure it is locked in place. Removing the Third Row Seats 1. Remove the cargo management system, if it is in the vehicle. See Cargo Management System on page 4‑3. 2. Remove anything on or under the seat. Installing the Third Row Seats 1. Before installing the seat the seatback must be folded forward. See "Folding the Seatback" earlier in this section.