2010 Buick LaCrosse Owner's Manual - Page 46

2-20 Seats and Restraints Slide the latch plate up the safety belt webbing, when the safety belt is not in use. The latch plate should rest on the stitching on the safety belt, near the guide loop on the side wall. Before a door is closed, be sure the safety belt is out of the way. If a door is slammed against a safety belt, damage can occur to both the safety belt and the vehicle. Adjustment" later in this section for instructions on use and important safety information. 4. To make the lap part tight, pull up on the shoulder belt. It may be necessary to pull stitching on the safety belt through the latch plate to fully tighten the lap belt on smaller occupants. Shoulder Belt Height Adjuster The vehicle has a shoulder belt height adjuster for the driver and right front passenger seating positions. Adjust the height so that the shoulder portion of the belt is centered on the shoulder. The belt should be away from the face and neck, but not falling off of the shoulder. Improper shoulder belt height adjustment could reduce the effectiveness of the safety belt in a crash. Press the release button (A) and move the height adjuster to the desired position. The adjuster can be moved up by pushing the slide/ trim up. After the adjuster is set to the desired position, try to move it down without pushing the release button to make sure it has locked into position. To unlatch the belt, push the button on the buckle. The belt should return to its stowed position.