2011 Buick LaCrosse Owner's Manual - Page 387

Vehicle Care The pressure gauge (D) may read higher than the actual tire pressure while the compressor is on. Turn the compressor off to get an accurate pressure reading. The compressor may be turned on/off until the correct pressure is reached. Notice: If the recommended pressure cannot be reached after approximately 25 minutes, the vehicle should not be driven farther. The tire is too severely damaged and the tire sealant and compressor kit cannot inflate the tire. Remove the power plug from the accessory power outlet and unscrew the inflating hose from the tire valve. See Roadside Assistance Program (U.S. and Canada) on page 13‑8 or Roadside Assistance Program (Mexico) on page 13‑10. 11. Press the on/off button (A) to turn the tire sealant and compressor kit off. The tire is not sealed and will continue to leak air until the vehicle is driven and the sealant is distributed in the tire; therefore, Steps 12 through 18 must be done immediately after Step 11. Be careful while handling the tire sealant and compressor kit as it could be warm after usage. 12. Unplug the power plug (G) from the accessory power outlet in the vehicle. 13. Turn the sealant/air hose (F) counterclockwise to remove it from the tire valve stem. 14. Replace the tire valve stem cap. 10-75 15. Return the sealant/air hose (F) and the power plug (G) back in their original locations. 16. If the flat tire was able to inflate to the recommended inflation pressure, remove the maximum speed label from the sealant canister and place it in a highly visible location. Do not exceed the speed on this label until the damaged tire is repaired or replaced. 17. Return the equipment to its original storage location in the vehicle. 18. Immediately drive the vehicle 8 km (5 mi) to distribute the sealant in the tire.