2013 Buick LaCrosse Owner Manual - Page 238

9-36 Driving and Operating If d comes on and stays on, reset the system. To reset: 1. Stop the vehicle. 2. Turn the engine off and wait 15 seconds. 3. Start the engine. If d still comes on and stays on, the vehicle needs service. . applies braking pressure to the vehicle brakes to help steer the vehicle in the intended direction. StabiliTrak comes on automatically whenever the vehicle is started. To assist with directional control of the vehicle, the system should always be left on. When StabiliTrak activates, d flashes on the instrument panel. A noise may be heard or vibration may be felt in the brake pedal. This is normal. Continue to steer the vehicle in the intended direction. See Traction Control System (TCS)/ StabiliTrak® Light on page 5‑21. If a problem is detected with StabiliTrak, SERVICE STABILITRAK is displayed on the Driver Information Center (DIC). See Ride Control System Messages on page 5‑37. When this message is displayed and d comes on and stays on, the vehicle is safe to drive but the system is not operational. Driving should be adjusted accordingly. To turn off both StabiliTrak and TCS, press and hold the TCS/ StabiliTrak button, located on the instrument panel, until i and g illuminate and the appropriate DIC message is displayed. See Ride Control System Messages on page 5‑37. When StabiliTrak is turned off, the system will not assist with directional control of the vehicle or limit wheel spin. Driving should be adjusted accordingly. See Traction Control System (TCS)/StabiliTrak® Light on page 5‑21. . Press and release the TCS/ StabiliTrak button again to turn the system back on. If cruise control is being used when StabiliTrak activates, cruise control will automatically disengage. Press the cruise control button to reengage when road conditions allow. See Cruise Control on page 9‑37.