2013 Buick LaCrosse Owner Manual - Page 246

9-44 Driving and Operating . Shift into P (Park). Reach a vehicle speed of 8 km/h (5 mph). WARNING (Continued) or under the vehicle. Perceived distances may be different from actual distances. Do not back the vehicle using only the RVC screen, during longer, higher speed backing maneuvers, or where there could be cross traffic. Failure to use proper care before backing may result in injury, death, or vehicle damage. Always check behind and around the vehicle before backing. An image appears on the navigation screen when the vehicle is shifted into R (Reverse). The navigation screen goes to the previous screen after approximately 10 seconds once the vehicle is shifted out of R (Reverse). To cancel the delay, do one of the following: . . Turning the Rear Vision Camera System On or Off To turn the RVC system on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Camera. When a checkmark appears next to the Camera option, then the RVC system is on. Symbols The navigation system may have a feature that lets the driver view symbols on the navigation screen while using the RVC. The Ultrasonic Rear Park Assist (URPA) system must not be disabled to use the caution symbols. The error message Rear Parking Assist Symbols Unavailable may display if URPA has been disabled and the symbols have been turned on. See Ultrasonic Parking Assist on page 9‑40. The symbols appear and may cover an object when viewing the navigation screen when an object is detected by the URPA system. To turn the symbols on or off: 1. Shift into P (Park). 2. Press the CONFIG button to enter the configure menu options. 3. Select Display. 4. Select Rear Camera Options. 5. Select Symbols. When a checkmark appears next to the Symbols option, symbols will appear. Press a hard key on the navigation system.