2013 Buick LaCrosse Owner Manual - Page 292

10-32 Vehicle Care 3. If replacing a turn signal/parking lamp bulb on a non-eAssist vehicle, remove the close out panel push pins and close out panel covering the bulb socket. 4. Remove the bulb socket from the headlamp by turning counterclockwise one-quarter turn. 5. Remove the bulb from the socket. If replacing the high/ low-beam bulb, pry the two clips on either end of the bulb and pull straight out. 6. Install the new bulb in the socket. 7. Install the bulb socket by turning clockwise one-quarter turn. 8. If a headlamp bulb was replaced, install the dust cover in the back of the headlamp housing by turning clockwise one-quarter turn. Uplevel Headlamp Assembly The uplevel model vehicle has a high intensity discharge (HID) high/ low beam, a dedicated DRL, and a parking/turn signal lamp on the headlamp assembly. See High Intensity Discharge (HID) Lighting on page 10‑31. 1. Low-Beam Headlamp/DRL 2. High-Beam Headlamp 3. Parking/Turn Signal Lamp To replace one of these bulbs: 1. Open the hood. See Hood on page 10‑5. 2. If replacing a headlamp bulb, remove the dust cover from the back of the headlamp housing by turning counterclockwise one-quarter turn. 1. DRL Lamp 2. Parking/Turn Signal Lamp To replace one of these bulbs: 1. Open the hood. See Hood on page 10‑5.