2013 Buick LaCrosse Owner Manual - Page 57

Seats and Restraints placed in OFF. These automatically stored positions are referred to as RKE Memory positions. See Remote Keyless Entry (RKE) System Operation on page 2‑3. Storing Button Memory Positions To save positions into Button Memory: 1. Adjust the driver seat, seatback recliner, and both outside mirrors to the desired driving positions. 2. Press and hold MEM (Memory) and "1" at the same time until a beep sounds. 3. Repeat Steps 1 and 2 for a second driver using "2." Recalling Button Memory Positions To recall the Button Memory positions, press and hold "1" or "2." The driver seat and outside mirrors move to the positions stored to those buttons when pressed. Releasing "1" or "2" before the stored positions are reached stops the recall. If something has blocked the driver seat while recalling a memory position, the recall may stop. Remove the obstruction; then press and hold the appropriate manual control for the memory item that is not recalling for two seconds. Try recalling the memory position again by pressing the appropriate memory button. If the memory position is still not recalling, see your dealer for service. Recalling RKE Memory Positions The RKE memory feature can recall the driver seat and outside mirrors to previously stored RKE Memory positions when entering the vehicle. Every time the ignition is placed in OFF, the positions of the driver seat and outside mirrors are automatically stored to the RKE transmitter that was used to start the vehicle. These positions are called RKE Memory positions and 3-7 may be different than the previously mentioned Button Memory positions saved to the "1" or "2" buttons. To recall RKE Memory positions: . On vehicles with RKE, press K on the RKE transmitter and open the driver door. On vehicles with keyless access, press the lock/unlock button on the outside driver door handle and open the door. The RKE transmitter must be present for the recall to activate. If the driver door is already open, press K on the RKE transmitter to activate the recall. . . The driver seat and outside mirrors will move to the previously saved RKE Memory positions. This feature is turned on or off using the vehicle personalization menu. See Vehicle Personalization on page 5‑39.