1993 Cadillac Eldorado Owner's Manual - Page 294

made especially for your automatic transaxle. Damage caused fluid by other than DEXRON@-IIE not coveredby your new vehicle warranty. is After adding fluid, recheck the fluid level as described under "How to Check." When the correct fluid level is obtained, push thedipstick back in all the way. How To Reset Transaxle Fluid Change Indicator: (4.6 Liter Northstar) Your vehicle is equipped with a transaxle fluid change indicator. A "CHANGE TRANS FLUID'' message will display on the Information Center when the power train computer determines that the transaxle fluid needs to bechanged or at each 100,000 miles (160,000 km) interval, whichever occurs first. When this message appears, change the transaxle fluid and resetthe transaxle fluid life indicator as follows: 0 Turn the key "ON" with the engine stopped. Press and hold the "OFF" and "REAR DEFOG" buttons on the "TRANS FLUID RESET" climate control simultaneously until the message appears in the Information Center (between and 20 5 seconds). ENGINE COOLANT The following explains your cooling system and how to add coolantwhen it is low. If you have a problem with engine overheating, see "Engine Overheating" in the Index. The proper coolant for your Cadillacwill: Give freezing protection down to -34" F (-37"C) . 0 Give boiling protection upto 262OF (128O C) . 0 Protect against rust and corrosion. Help keep the proper engine temperature. Let the warning lightswork as they should. What to Use: Use a mixture of one-half clean water (preferably distilled) one-half and antifreeze that meets "GM Specification 1825-M," won't damage which aluminum parts. You can also use a recycled coolant conforming to GM 280