1998 Cadillac DeVille Owner's Manual - Page 132
1998 Cadillac DeVille Manual
Page 132 highlights
already. If the amber light on the universal transmitter flashes rapidly for one or two seconds and then stops flashing, the garage door opener has a rolling code system. In a rollingcode system, the garage door receiver must be trained to the universal transmitter. Training a Garage Door Opener with "Rolling Codes" (If Equipped) 3. Return to the universal transmitter in your vehicle and press the universal transmitter button you have already programmed fortwo to three seconds. Press the button again to make sure that the universal transmitter has been trained to the garage door opener receiver. Check that the training was successful. The receiver light should no longer beflashing. The garage door opener should now recognize the universal transmitter. You may either usethe universal transmitter or the hand-held transmitter open the to garage door. If you have not previously programmed the hand-held transmitter tothe universal transmitter,see "Programming the Transmitter" earlierin this section.If you have completedthis programming already, you now If after following these instructions you still have problems need to' train garage door opener receiver to the training the garage door opener, consult your dealer. recognize the universal transmitter. Refer to your garage door opener owner's manual the proper transmitter for Erasing Channels training procedurefor your garage door opener brand. To erase all three programmed channels, hold down the 1. Locate the training buttonon the garage door opener two outside buttons until the red begins to flash. light receiver. The exact location and color the button of Individual channels cannot be erased, but be can If may vary by garage door opener brand. you have reprogrammed using the procedure for programming the to difficulty locating the training button, refer your transmitter explained earlier. garage door opener manual. 2. Press the training button on the garage door opener two receiver for one or seconds. A light indicator will begin to flash when the receiver enters the train mode. Accessories Accessories for the universal transmitter are available from the manufacturer of the unit. If you would like 15. additional information, please 1-800-355-35 call 2-61