1999 Cadillac Catera Owner's Manual - Page 117

yellowblue Programming the Sunroof If the battery on your vehicle has been recharged, disconnected or is not working, you will need to reprogram the sunroof following these steps. Refer to the illustration under "Sunroof" for control dial positions. With your vehicle's ignition on: 1. If the sunroof is closed, turn the control dial to position E. Hold the dial in position for about five seconds. If the sunroof is open, turn the control dial to E and hold until the glass panel has closed. Now continue holding the dial for approximately five more seconds. 2. Turn the control dial to position G and hold until the sunroof is fully tilted (about three seconds after the motor has stopped). 3. Now turn the control dial to position E and keep holding until the sunroof is fully closed (about three seconds after the motor has stopped). 4. Turn the control dial to position A and hold until the sunroof is fully open (about three seconds after the motor has stopped). 5. Turn to position E and keep holding the control dial until the sunroof has fully closed (about three seconds after the motor has stopped). The sunroof is now programmed. Note: If the sunroof keeps opening after you attempt to close it once it has been programmed, you will need to repeat Steps 2 through 5 (up to three times if needed). If you are still having problems, consult your dealer for service. Also keep in mind that if something is in the way of the sunroof closing during programming and you continue to program the sunroof, the sunroof will only open or close to the spot where the obstruction occurred. You will need to reprogram the sunroof again, making sure that the object has been removed. 2-55