2003 Cadillac Escalade Owner's Manual - Page 213

To adjust all tone and speaker controls to the middle position, push and hold the AUDIO knob when no tone or speaker control is displayed. The radio will produce one beep and display ALL with the level display in the middle position. 2. Select a category by turning the P-TYPE LIST knob. 3. Once the desired category is displayed, press either SCAN arrow, and the radio will begin scanning within your chosen category. Finding a PTY Station (RDS and XMTM) To select and find a desired PTY perform the following: 1. Turn the P-TYPE LIST knob. TYPE and a PTY will appear on the display. 2. Select a category by turning the P-TYPE LIST knob. 3. Once the desired category is displayed, press the SEEK TYPE button or one of the SEEK arrows to take you to the category's first station. 4. If you want to go to another station within that category and the category is displayed, press the SEEK TYPE button once. If the category is not displayed, press the SEEK TYPE button twice to display the category and then to go to another station. If the radio cannot find the desired program type, NONE will appear on the display and the radio will return to the last station you were listening to. 3. Press wither SCAN arrow again to stop scanning. BAND (Alternate Frequency): Alternate frequency allows the radio to switch to a stronger station with the same program type. Press and hold BAND for two seconds to turn alternate frequency on. AF ON will appear on the display. The radio may switch to stronger stations. Press and hold BAND again for two seconds to turn alternate frequency off. AF OFF will appear on the display. The radio will not switch to other stations. This function does not apply for XMTM. Setting Preset PTYs (RDS Only) The six numbered pushbuttons let you return to your favorite PTYs. These buttons have factory PTY presets. You can set up to 12 PTYs (six FM1 and six FM2) by performing the following steps: 1. Press BAND to select FMl or FM2. SCAN: You can also scan through the channels within a category by performing the following: 1. Turn the P-TYPE LIST knob. TYPE and a PTY will appear on the display. 3-70 2. Turn the P-TYPE LIST knob. TYPE and a PTY will appear on the display. 3. Turn the P-TYPE LIST knob to select a PTY.