2004 Cadillac DeVille Owner's Manual - Page 210

When battery power is removed and later applied, you will not have to reset your radio presets because the radio remembers them. Finding a Program Type (PTY) Station (XM™ Only) To select and find a desired PTY perform the following: 1. Press PTY to activate program type select mode. PTY will appear on the display. 2. Press LEVEL to select a PTY. 3. Once the desired PTY is displayed, press either TUNE SEEK arrow to select the PTY and take you to the PTY's first station. 4. If you want to go to another station within that PTY, press TUNE SEEK once to display the PTY, then press TUNE SEEK again to go to another station. 5. Press PTY to exit program type select mode. If PTY times out and is no longer on the display, go back to Step 1. SCAN: You can scan the stations within a PTY by performing the following: 1. Press PTY to activate program type select mode. PTY will appear on the display. 2. Press LEVEL to select a PTY. 3. Once the desired PTY is displayed, press SCAN, and the radio will begin scanning the stations in the PTY. 4. Press SCAN to stop at a station. Setting the Tone (Bass/Treble) TONE: Press and release this button until the BASS, TREBLE, or MIDRANGE appears on the display. The radio keeps separate tone settings for each band, preset, and source. − LEVEL +: After selecting the desired tone control, press the plus or minus button to select the desired level. To save the tone settings for your presets, press and hold the numbered pushbutton for the desired preset for more than two seconds until you hear a beep. Adjusting the Speakers (Balance/Fade) M (Speaker): Press and release this button until BALANCE or FADE appears on the display. − LEVEL +: After selecting the desired control, press the plus or minus button to select the desired level. PTY (Program Type): This button is inoperable on this radio, except if your radio is equipped with XM™ Satellite Radio Service. 3-84