2004 Cadillac Escalade EXT Owner's Manual - Page 139

Cargo Cover To remove the cover from the vehicle, do the following: 1. Let the cover go all the way into the holder. 2. Then, grasping the passenger's side cover endcap, push the cover endcap toward the driver's side of the vehicle. The endcap should lock in the compressed position. 3. Lift the cover up on the passenger's side, swing the cover rearward and take it out of the vehicle. To put the cover in the vehicle, do the following: 1. Make sure the cover slot in the holder faces rearward with the round surface facing down. 2. Then, hold the cover at an angle and place the cover holder tab into the slot in the driver's side trim panel. 3. Move the other end of the cover forward and hold it next to the passenger's side trim panel slot. 4. Push the button on top of the passenger's side endcap. This will allow the cover to extend into the trim slot. 5. Lightly pull on the cover holder to make sure it is secure. On some models there are two slots. The slots furthest forward allow the cover to be used if the third seat is removed or folded down. {CAUTION: An improperly stored cargo cover could be thrown about the vehicle during a collision or sudden maneuver. You or others could be injured. If you remove the cover, always store it in the proper storage location. When you put it back, always be sure that it is securely reattached. If you have a cargo cover, you can use it to cover items in the cargo area of your vehicle. To use the cover, do the following: 1. Pull the cover handle toward the rear of the vehicle. 2. Latch the cover posts into the retaining sockets on the cargo area trim panels. To return the cover to the retracted position, do the following: 1. Pull up on the cover handle to release the cover posts from the retaining sockets. 2. Let the cover move forward to the full retracted position. 2-45