2004 Cadillac SRX Owner's Manual - Page 363

8. Reinstall the two fasteners on top of the headlamp assembly. 9. Reinstall the screw at the lower inboard side of the headlamp assembly through the hole in the bracket into the headlamp. 10. Reinstall the fasteners along the top surface of the front fascia. To replace the sidemarker and/or parking lamp bulb(s), do the following: 1. Turn the bulb socket counterclockwise to remove it from the assembly. 2. Replace the bulb. See Replacement Bulbs on page 5-55 for the proper bulb number. 3. To reinstall the headlamp assembly, reverse Steps 5 through 10 of the procedure listed previously. Front Turn Signal and Fog Lamps To replace the front turn signal and/or fog lamp bulb(s), do the following: 1. Remove the protection shield located on the underside of the front of the vehicle by pulling out the push-pins located on the underside of the shield. If you are replacing a bulb on the passenger's side, also use a tool to remove the fasteners that attach the front fascia extension panel in the wheelhouse. 2. Remove the two screws located on the inboard side and bottom of the lamp assembly that attach the lamp assembly to the front fascia. 3. Remove the lamp assembly from the front fascia by rotating the lamp assembly rearward to disengage the outboard hooks of the lamp from the slots in the front fascia. 4. Disconnect the electrical harness connector from the back side of the lamp assembly. 5. Remove the six Torx® screws located on the access cap. 5-53