2004 Cadillac SRX Owner's Manual - Page 381

5. Start with the left (driver's side) front tire. 6. Remove the valve cap from the valve stem. Activate the TPM sensor by increasing or decreasing the tire's air pressure for 5 seconds, or until a horn chirp sounds. The horn chirp, which may take up to 30 seconds, confirms that the sensor identification code has been matched to this tire position. To decrease the tire's air-pressure use the pointy end of the valve cap, a pencil-style air pressure gage or a key. 7. Proceed to the right (passenger's side) front tire, and repeat the procedure in step 6. 8. Proceed to the right (passenger's side) rear tire, and repeat the procedure in step 6. 9. Proceed to the left (driver's side) rear tire, and repeat the procedure in step 6. 10. After hearing the confirming double horn chirp, for the left rear tire, exit the matching process by turning the ignition switch to OFF. 11. Set all four tires to the recommended air pressure level as indicated on the tire and loading information label. 12. Put the valve caps back on the valve stems. The spare tire does not have a TPM sensor. If you replace one of the road tires with the spare, the SERVICE TIRE MONITOR message will be displayed on the DIC screen. This message should go off once you re-install the road tire containing the TPM sensor. The SERVICE TIRE MONITOR message is also displayed when the TPM system is malfunctioning. One or more missing or inoperable TPM sensors will cause the service tire monitor message to be displayed. See your dealer for service. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: 1. this device may not cause interference, and 2. this device must accept any interference received, including interference that may cause undesired operation. This device complies with RSS-210 of Industry Canada. Operation is subject to the following two conditions: 1. this device may not cause interference, and 2. this device must accept any interference received, including interference that may cause undesired operation of the device. Changes or modifications to this system by other than an authorized service facility could void authorization to use this equipment. 5-71