2006 Cadillac DTS Owner's Manual - Page 344

Headlamp Aiming The vehicle has a visual optical headlamp aiming system. The aim has been preset at the factory and should need no further adjustment. However, if the vehicle is damaged in an accident, the headlamp aim may be affected and adjustment may be necessary. If oncoming vehicles flash their high beams at you, this may also mean the vertical aim needs to be adjusted. It is recommended that the vehicle is taken to your dealer for service if the headlamps need to be re-aimed. It is possible however, to re-aim the headlamps as described in the following procedure. Notice: To make sure your headlamps are aimed properly, read all the instructions before beginning. Failure to follow these instructions could cause damage to headlamp parts. The vehicle should be properly prepared as follows: • The vehicle should be placed so the headlamps are 25 ft. (7.6 m) from a light colored wall or other flat surface. • The vehicle must have all four tires on a level surface which is level all the way to the wall or other flat surface. • The vehicle should be placed so it is perpendicular to the wall or other flat surface. • The vehicle should not have any snow, ice, or mud on it. • The vehicle should be fully assembled and all other work stopped while headlamp aiming is being performed. • The vehicle should be normally loaded with a full tank of fuel and one person or 160 lbs (75 kg) sitting on the driver's seat. • Tires should be properly inflated. • The spare tire is in its original location in the vehicle. 5-44