2007 Cadillac STS Owner's Manual - Page 458

9. Inflate the tire up to the recommended inflation pressure, found on the Tire and Loading Information label located on the vehicle's center pillar (B-pillar) below the vehicle's door latch, using the air pressure gage on the top of the unit. The pressure gage reading is slightly high while the compressor is on. Turn the compressor off to get an accurate pressure reading. Notice: If the recommended pressure cannot be reached after 15 minutes, the vehicle should not be driven farther. Damage to the tire is severe and the sealant will not be effective. Remove the air compressor plug from the accessory power outlet and unscrew the inflating hose from the tire valve. See Roadside Service on page 531. 10. Move the inflator kit switch to the O (off) position once the correct tire pressure is obtained. 11. Turn off the engine. 12. Unplug the air compressor accessory plug from the accessory power outlet in the vehicle. 13. Disconnect the sealant filling hose from the tire valve stem, by turning it counterclockwise, and replace the tire valve stem cap. Be careful when handling the tire inflator components as they may be hot after usage. 14. Wrap the sealant filling hose around the air compressor channel to stow it in its original location. 15. Stow the air compressor accessory plug back in the air compressor. To do this, wrap the air compressor accessory plug, snap in the plug, and then push in the bottom and then the top of the wrapped air compressor accessory plug. 458