2008 Cadillac XLR-V Owner's Manual - Page 161

You can switch from English to metric units through the Driver Information Center (DIC). See DIC Operation and Displays on page 3-60 for more information. The air conditioning system removes moisture from the air, so you may sometimes notice a small amount of water dripping underneath your vehicle while idling or after turning off the engine. This is normal. Do not cover the solar sensor located in the center of the instrument panel, near the windshield. For more information on the solar sensor, see "Sensors" later in this section. «9ª(Fan): Press this switch to increase or decrease the fan speed. Pressing this switch cancels automatic operation and places the system in manual mode. Press AUTO to return to automatic operation. If the airflow seems low when the fan speed is at the highest setting, the passenger compartment air filter may need to be replaced. For more information, see Passenger Compartment Air Filter on page 3-42 and Scheduled Maintenance on page 7-4. Manual Operation w PWR x (Power/Temperature): Press the PWR button on the left side of the climate control panel to turn the entire climate control system on or off. Press the up or down arrow on the switch to manually increase or decrease the temperature inside the vehicle. Press the PWR button on the right side of the climate control panel to turn the passenger's climate control system on or off. Press the up or down arrow on the switch to manually increase or decrease the temperature for the passenger. If the passenger's PWR button is off, the driver's temperature switch controls the temperature for the entire vehicle. ªN«(Mode): Pressing the switch and changing the mode cancels automatic operation and places the system in manual mode. Press the AUTO button to return to automatic operation. To change the current mode, select one of the following: H (Vent): This mode directs air to the instrument panel outlets. % (Bi-Level): This mode directs about half of the air to the instrument panel outlets, and then directs most of the remaining air to the floor outlets. In automatic operation, cooler air is directed to the upper outlets and warmer air to the floor outlets. 6 (Floor): This mode directs most of the air to the floor outlets with some air directed to the side window outlets, and some of the air directed to the windshield. The mode switch can also be used to select the defog mode. Information on defogging and defrosting can be found later in this section. 3-39