2010 Cadillac STS Owner's Manual - Page 270

STABILITY SECURE MODE If your All-Wheel Drive (AWD) vehicle has the Active Steering with Enhanced StabiliTrak option, this message displays when the stability control system is in the secure mode. Stability Secure Mode is set automatically when certain system faults or vehicle conditions are detected. When the Stability Secure Mode is activated, the stability control system will not respond to driver requests to change the stability mode until the next ignition cycle or until the vehicle condition or fault is returned to normal. See Enhanced StabiliTrak® on page 5‑7 for more information. STABILITY SYS (System) NOT READY This message displays if the StabiliTrak system is not ready. Two conditions may cause this message to display: . The vehicle needs to be driven in a straight line until the sensors are centered. Once the sensors are centered, the StabiliTrak system is ready and the STABILITY SYS READY message displays. The system needs to warm up. This may occur when first starting your vehicle and driving away during cold winter weather. This is normal. To acknowledge this message, press the reset button. . STABILITY SYS (System) ACTIVE This message displays any time the StabiliTrak system or Enhanced StabiliTrak system is actively assisting with directional control of the vehicle. Slippery road conditions may exist when this message is displayed, so adjust your driving accordingly. This message may stay on for a few seconds after StabiliTrak stops assisting with directional control of the vehicle. See StabiliTrak® System on page 5‑6 or Enhanced StabiliTrak® on page 5‑7 for more information. The StabiliTrak performance is affected until the STABILITY SYS READY message is displayed in the DIC. See StabiliTrak® System on page 5‑6 for more information. STABILITY SYS (System) OFF This message displays any time StabiliTrak or Enhanced StabiliTrak is turned off using the TC (traction control) on/off button. See Traction Control System (TCS) on page 5‑9 and "Enhanced StabiliTrak and Traction Control Mode Selection" under Enhanced StabiliTrak® on page 5‑7 for more information. When this message has been displayed, StabiliTrak or Enhanced StabiliTrak is no longer available to assist 4-90