2010 Cadillac STS Owner's Manual - Page 299

Using the Digit Dial Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Digit Dial". The system responds with "Digit dial using , please say the first digit to dial" followed by a tone. 3. Say the digit to be dialed one at a time. Following each digit, the system will repeat back the digit it heard followed by a tone. 4. Continue entering digits until the number to be dialed is complete. After the whole number has been entered, say "Dial". The system responds with "OK, Dialing" and dials the number. . Using the Call Command 1. Press and hold b g for two seconds. The system responds with "Ready" followed by a tone. 2. Say "Call". The system responds with "Call using . Please say the name tag" followed by a tone. 3. Say the name tag of the person to call. . If the system clearly recognizes the name tag it responds with "OK, calling, " and dials the number. If the system is unsure it recognizes the right name tag, it confirms the name tag followed by a tone. If the name tag is correct, say "Yes". The system responds with "OK, calling, " and dials the number. If the name tag is not correct, say "No". The system will ask for the name tag to be re‐entered. . If an unwanted number is recognized by the system, say "Clear" at any time to clear the last number. To hear all of the numbers recognized by the system, say "Verify" at any time and the system will repeat them. . Once connected, the person called will be heard through the audio speakers. 4-119