2014 Cadillac CTS Owner Manual - Page 38

2-8 Keys, Doors, and Windows 13. A beep sounds once programming is complete. The DIC displays READY TO LEARN ELECTRONIC KEY # 2. To program additional transmitters, insert each transmitter in the pocket until a beep is heard and the DIC advances to the next electronic key number. Up to eight transmitters can be programmed. The DIC displays MAXIMUM # ELECTRONIC KEYS LEARNED and exits the programming mode. 14. Press the ignition control knob if programming is complete. 15. Press K on each newly programmed transmitter to complete the process. 5. The DIC displays PRESS START CONTROL TO LEARN KEYS. 6. Press the ignition switch in. 7. The DIC reads LEARN DELAY ACTIVE WAIT XX MIN and counts down to zero. 8. The DIC displays PRESS START CONTROL TO LEARN KEYS again. 9. Press the ignition switch in again. 10. Repeat Steps 7, 8, and 9. 11. The DIC reads LEARN DELAY ACTIVE WAIT XX MIN and counts down to zero. 12. A beep sounds and the DIC reads READY TO LEARN ELECTRONIC KEY # X. All previously known transmitter programming has been erased. Starting the Vehicle with a Low Transmitter Battery Replace the battery if the REPLACE BATTERY IN REMOTE KEY message displays in the DIC. See "Replace Battery In Remote Key" under Key and Lock Messages on page 5-37 for additional information. If the transmitter battery is weak, the DIC may display ELECTRONIC KEY NOT DETECTED when you try to start the vehicle. To start the vehicle, place the transmitter in the center console storage area transmitter pocket with the buttons facing to the front of the vehicle. Then, with the vehicle in P (Park) or N (Neutral), press the brake pedal and the ignition control knob. See Starting the Engine on page 9-20, for additional information about the vehicle's electronic keyless ignition. Replace the transmitter battery as soon as possible.