2014 Cadillac CTS Owner Manual - Page 70

3-8 Seats and Restraints To recall, press and release "1" or "2." The vehicle must be in P (Park) for an automatic transmission, or the parking brake must be applied for a manual transmission. A single beep sounds when the button is pressed. The seat, outside mirrors, and/or power steering column move to the position previously stored for the identified driver. Automatic Entry Recall If entry/exit recall is programmed on in the vehicle personalization menu, automatic entry recall occurs when the ignition is turned on. See Vehicle Personalization on page 5-46. To stop recall movement, press one of the power seat, memory, or outside mirror buttons, or the power steering column switch (if equipped). If something has blocked the driver seat or the steering column while recalling a memory position, the recall may stop. Remove the obstruction; then press the appropriate control for the area that is not recalling for two seconds. Try recalling the memory position again by pressing the appropriate memory button. If the memory position is still not recalling, see your dealer for service. Exit Recall B (Exit Button): Moves the driver seat and/or power steering column to the exit position. See "Exit Recall" later in this section. Storing Memory Positions To save into memory: 1. Adjust the driver seat, outside mirrors, and the power steering column (if equipped) to the desired driving positions. 2. Press and hold "1" until two beeps sound. 3. Repeat for a second driver using "2." The vehicle comes with two Remote Keyless Entry (RKE) transmitters. Each transmitter has a number "1" or "2" on it. These numbers correspond to "1" and "2" on the driver door. The current driver is identified when K on the RKE transmitter is pressed, or when "1" or "2" on the driver door is pressed. B (Exit Button): Press to move the driver seat back a preset distance and/or the power steering column (if equipped) up and forward. A single beep sounds when the exit feature activates. The vehicle must be in P (Park) for an automatic transmission, or the parking brake must be applied for a manual transmission. If entry/exit recall is programmed on in the vehicle personalization menu, automatic seat and/or steering column movement occurs upon leaving the vehicle, if the following conditions are met. See Vehicle Personalization on page 5-46.