1994 Chevrolet Camaro Owner's Manual - Page 121
1994 Chevrolet Camaro Manual
Page 121 highlights
~ 5. Press "SET" and "000" will appear on the display. 6. Press "SEEK 4 or "SEEK b " and hold until the firstdigit of your code appears. Releasethe button. 7. T r the lower knob to make the un second and third digits appear. 8. Press the lower knob and "000" will appear on thedisplay. Now you are ready to enter the last three digits of your code. 9. Press "SEEK 4 or "SEEK b " and hold until the fourthdigit of your code appears. Release the button. 10. Turn the lower knobto make the fifth and sixth digits of your code appear. 11. Press the lower knob. "rEP" will appear for five seconds, then and "000" will appear. 12. For verification, repeat steps 6 through 11. If "SEC" appears, your audio system is secured.If "---" shows on the display, your system is not secured. You must restart the entire procedure again from step 5. " " Shutting Off the Theft-Deterrent Feature If your audio system is secured ("SEC" shows on display) and you wish to disable it, enter your security code as follows, pausing no more than 15 seconds between steps: 1. Turn the ignition on. Make sure the audio system is off. The time will show on the display. 2. Press pushbuttons "1" and "4" together until "SEC" shows on the display. 3 Press "SET." "000" will appear on the . display. 4. Press "SEEK 4 or "SEEK b and hold until the first digit of your code appears. Release the button. 5. Turn the lower knob until the second and third digits appear. 6. Press the lower knob. "000" will appear on the display. 7. Press "SEEK 4 or "SEEK b and hold until the fourth digit of your security codeappears. Release the button. 8. Turn the lower knob until the fifth and sixth digits of your code appear. 9. Press the lower knob. If "---" shows, you have shut off the theft-deterrent feature. If "SEC" shows, your audio system is still secured. NOTE: If you lose or forget your security code, seeyour dealer forassistance. Unlocking the Audio System after a Power Failure If power is disrupted to the audio system while in the "SEC" mode, the unit will not work and "LOC" will show on the display whenever the ignition is on. To unlock the unit: 1. Turn the ignition switch to the "Acc" or "Run" position. 2. Press "SEEK 4 or "SEEK b and hold until the first digit of your code appears. Release the button. 3 Turn the lower knob to make the . second and third digits appear. 4. Press the lower knob. "000" will appear on the display. 5. Press "SEEK 4 " or "SEEK b and hold until thefourth digit of your security code appears. Release the button. " " " 119...