1994 Chevrolet Camaro Owner's Manual - Page 210
1994 Chevrolet Camaro Manual
Page 210 highlights
Service and Appearance Care 5. Plug the wiring connector intothe headlight socket. Snap the locking tabs onto the socket. 6. Place the new headlight in the headlight assembly. The socket must be pointing in the same direction the socket on the burned out bulb was. 7. Insert the tabs on the aiming ring into the tabs in the headlight assembly. 0. Hold the aiming ring closed, insert the screws at the end of the ring. Tighten 2. The aiming ring will swing open like a 3 Pull the headlight out of the assembly. the screws until the aiming ring gate. Remove the aiming ring from thl e Remove the wiring connector from thl touches the plastic nuts on both the assembly. Place it face down, with the headlight socket by lifting the plastic top and bottom. Do not overtighten. aim indicator up. Be careful not to locking tabs on the connector and Do not damage the vertical aiming damage the aiming bubble. pulling it from the socket. bubble. 4, Check the new headlight again. The number of the light must match the number on the headlight being replaced. The letter "U" or "L" must also match. I - ...208