1994 Chevrolet Camaro Owner's Manual - Page 87

T-Top Sunshades 1. Start with the panel marked "DRIVER FRONT." Unlatch the driver-side T-top, raise it halfway and close the latch handle. 2. With the top raised and resting on the center roof rail, slide the flat edge of the sunshade panel (with the vinyl side to the glass) between the glass and plastic trim, making sure the edge marked "DRIVER FRONT" is pointing to the front of the vehicle. 3 Open the latch and close the T-top. . 5. Pull the sunshade back a little and remove the backing paper from the Check to see if there are any gaps Velcro@buttons. Push the sunshade showing. Unlatch the T-top and adjust back into place sticking the Velcro@ the sunshade as required. to the glass. 4. Once the sunshade is installed 6. Install the T-top, close the latch and properly, you can stick the Velcro@ lock the T-top. Repeat the above steps buttons on the glass for a proper fit for the passenger-side sunshade. every time you install the sunshades. To do this, first remove the T-top with the sunshade installed and place it upside down on a table or bench. Tdke care not to scratch the glass. 85.