1996 Chevrolet S10 Pickup Owner's Manual - Page 128

Locking the Theft System 1. Write down any six-digit number and keep it in a safe place separate from the vehicle. Unlocking the Theft System After Power Loss a Enter your secret code as follows; pause no more than 15 seconds between steps: 2. Turn the ignition to the ACCESSORY or RUN position. 1. Turn the ignition on with the radio off. 2. Press SET and 000 will appear on the display. 3. Press SCAN to make the first digit appear. 4. Press SEEK right arrow or SEEK left arrow to make the next two digits agree with your code. 3. Press POWER to turn the radio off. 4. Press the 1 and 4 buttons together. Hold them down until --- shows on the display. Next you willuse the secret code number which you have written down. 5. Press SET and 000 will appear on the display. 6. Press SCAN to make the first digit appear. 7. Press SEEK right arrow or SEEK left arrow to make the next two digits agree with your code. 5. Press BAND and 000 will appear on the display again. Now you are ready to enter the last three digits of your code. 6. Repeat Steps 3 and 4 for the last three digits of your code. 7. Press BAND after you have confirmed that the code 8. Press BAND and 000 will appear on the display again. Now you are ready to enter the last three matches the secretcode you have written down. The digits of your code. time will be displayed indicating that the systemis disabled. If the display shows SEC, the numbers 9. Repeat Steps 6 and 7 for the last three digits of entered did not match your secretcode and the unit your code. is still secured. 10. Press BAND and the display will show REP for about to When battery power is given a secured radio, the five seconds and then 000 will appear on the display. radio won't turn on and LOC willappear on the display. 11. Repeat Steps 6 through 10. This time the display will show SEC to let you know that your radio secure. is 3-15