1996 Chevrolet S10 Pickup Owner's Manual - Page 221
1996 Chevrolet S10 Pickup Manual
Page 221 highlights
1. Put the tire on the ground at the rear of the vehicle, with the valve stem pointed down and to therear. 2. Pull the retainer through the wheel. Note that with the ZR2 option, the spring and retainer must be separated to insert through the wheel opening. Return the jack, wheel wrench and wheel blocks to the proper location behind the seat. Secure the items. 3. Put the chisel end of the wheel wrench, on an angle, through the hole in the rear bumper and into the hoist shaft. Turn thewheel wrench clockwise until the tire is raised against the underside of the vehicle. You will hear two "clicks" when the tire is secure, but pull on the tire to make sure. A. Wheel Wrench B. Bracket E. Bolt Location E WheelBlocks G . Nut H. Rubber Band (ZR2) C . Jacking Instructions (Roll and place tag behind the bracket after the tools are installed.) D. Bolt Location (Standard) I. Jack Position (ZR2) J. Jack Position (Standard) 5-31