1996 Chevrolet S10 Pickup Owner's Manual - Page 266
1996 Chevrolet S10 Pickup Manual
Page 266 highlights
Taillamps 1. Open the tailgate. 2. Remove the screws from the lamp assembly near the tailgate latch. 4. Install a new bulb. 5. Replace the lens. Install and tighten the screws. If equipment such as a or camper is installed on cap your vehicle, acenter high-mounted stoplamp feed wire is provided along the driver's side rear frame. This wire should be used to install a center high-mounted stoplamp in thecap orcamper. 3. Pull the assemblyaway from the pickup side panel. 4. Turn the socketcounterclockwise to remove it. Push the tab in while you turn the socket. 5. Pull the bulb out. into 6. Push the new bulb the socket. 7. Put the socketinto the assembly and turn the socket clockwise until it locks in place. 8. Replace the assembly. Install and tighten the screws. 9. Close the tailgate. 6-40