1997 Chevrolet S10 Pickup Owner's Manual - Page 277
1997 Chevrolet S10 Pickup Manual
Page 277 highlights
3. Remove.the bulb. Taillamps 1.. Open the tailgate; 2. Re,movethe-.screwsf r ~ m the lamp assembly n e a the tailgate latch.. 4. Insrall a new bulb? and tighten the screws. If equipment--such a cap or camper is installed on as your vehicle, a center high-mounted stoplamp feed wire is provided along the driver's s.iid& fram-e.This wire rear ,-rshouldbe used to install a center high-mounted '-stoplanip in the cap 'or c.mper; 3. Pull the assembly away from the pickup side.panel. 4. Turn the socket countexclockwise to remove it. Push the tab. i-n while you turn the s,ocket. 5. Pull the bulb out. ,6. Push the new bulb into the socket-. 7. Put the scrcket into the assembly and.ttlrn the s:ocket c l o c k w k until it locks into-place-: 8. Rep1.ac-e-the assembly. Install and tighten the screws, -9. Close the tailgate. 6-40