2000 Chevrolet Prizm Owner's Manual - Page 235

If the fluid level is low, add only enough of the proper fluid to bring the level into the area between dimples on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It doesn't take much fluid, generally less than one pint (0.5 L). Don't overfill. 3. Check both sides of the dipstick, and read the lower level. The fluid level must be between the two dimples in the hot range. 4. If the fluid level is in the acceptable range, push the dipstick back in all the way; then press the tab down to lock the dipstick in place. NOTICE: We recommend you use only fluid labeled DEXRONR-III, because fluid with that label is made especially for your automatic transaxle. Damage caused by fluid other than DEXRONR-III is not covered by your new vehicle warranty. 3. After adding fluid, recheck the fluid level as described under "How to Check." 4. When the correct fluid level is obtained, push the dipstick back in all the way; then press the tab down to lock the dipstick in place. How to Add Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See "Recommended Fluids and Lubricants" in the Index. 6-19