2000 Chevrolet Silverado 1500 Pickup Owner's Manual - Page 250

yellowblue Your dealer can help you make a good vehicle-camper match. He'll also help you determine your CWR. After you've loaded your vehicle and camper, drive to a weigh station and weigh the front and rear wheels separately. This will tell you the loads on your axles. The loads on the front and rear axles shouldn't be more than either of the GAWRs. The total of the axle loads should not be more than the GVWR. Open your driver's door and look at the Certification/Tire label to find out your GAWR and GVWR. If you've gone over your weight ratings, move or take out some things until all the weight falls below the ratings. Of course, you should always tie down any loose items when you load your vehicle or camper. When you install and load your slide-in camper, check the manufacturer's instructions. If you want more information on curb weights, cargo weights, Cargo Weight Rating and the correct center of gravity zone for your vehicle, your dealer can help you. Just ask for a copy of "Consumer Information, Truck-Camper Loading." Trailer Recommendations You must subtract your hitch loads from the CWR for your vehicle. Weigh your vehicle with the trailer attached, so that you won't go over the GVWR or GAWR. If you are using a weight-distributing hitch, weigh the vehicle without the equalizer bars in place. You'll get the best performance if you spread out the weight of your load the right way, and if you choose the correct hitch and trailer brakes. For more information, see "Trailer Towing" in the Index. Camper Wiring Harness (If Equipped) If your vehicle is equipped with a camper wiring harness see "Trailer Wiring Harness" in the Index for further information. 4-54