2001 Chevrolet Camaro Owner's Manual - Page 86

When your vehicle was shipped from the factory, it was programmed in Mode 4. The mode to which the vehicle has been programmed may have been changed since it left the factory. To determine the mode to which your vehicle is programmed or to program your vehicle to a different mode, do the following: 1. Turn the parking lamps on and off. 2. Count the number of chimes you hear. The number of chimes tells you which mode your vehicle is set for. (If you do not wish to change the current mode, you can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle.) 3. Turn the parking lamps on and off again until you hear the number of chimes that corresponds to the mode selection you want. The mode you selected is now set. You can either exit the programming mode by following the instructions later in this section or program the next feature available on your vehicle. New Vehicle "Break-In" NOTICE: Your vehicle doesn't need an elaborate "break-in." But it will perform better in the long run if you follow these guidelines: D Keep your speed at 55 mph (88 km/h) or less for the first 500 miles (805 km). D Don't drive at any one speed -- fast or slow -- for the first 500 miles (805 km). Don't make full-throttle starts. D Avoid making hard stops for the first 200 miles (322 km) or so. During this time your new brake linings aren't yet broken in. Hard stops with new linings can mean premature wear and earlier replacement. Follow this breaking-in guideline every time you get new brake linings. D Don't tow a trailer during break-in. See "Towing a Trailer" in the Index for more information. Exiting Programming Mode When programming is complete, turn the ignition to OFF and reinstall the RADIO fuse. 2-28