2002 Chevrolet Silverado 1500 Pickup Owner's Manual - Page 326

To use PTO speed control in variable mode (while stationary) do the following: 1. Engage the PTO. 2. Vehicle speed must be less than 5 mph. 3. Make sure your foot is off the brake pedal (and off the clutch for vehicles equipped with a manual transmission). 4. Select the desired engine speed by using the foot pedal, and select SET on the PTO switch or the cruise control. Variable Mode: PTO speed control mode can be used for both stationary and mobile applications. This mode allows PTO to be controlled in a fashion similar to how cruise control sets vehicle speed. The operator can set to an rpm (between 800 and 2200) with the cruise control feature or with the SET position on the PTO switch. The operator is then able to increase rpm in increments of 100, or "tap up", with the resume position on the cruise control. Or, the operator can decrease rpm in increments of 100 with the SET switch on the PTO or the cruise control. Vehicles not equipped with cruise control will not have the "tap up" capability. All engine speed values listed above are factory preset values. With the exception of the TCC lockup speed (1100 rpm) and the "tap" increment (100 rpm), all of these values are programmable and can be adjusted by your dealer or body upfitter. If the PTO software settings do not match the settings shown here, then they may have already been altered in order to satisfy the requirements of the installed PTO system and body equipment. Step-Bumper Pad Your vehicle has a rear step bumper with a rear step pad at the center of the bumper. If you will be using the bumper to tow a trailer, you must remove the center cutout circle to install the trailer ball. 4-98