2002 Chevrolet Silverado 1500 Pickup Owner's Manual - Page 393

Hot Check Procedure The fluid must be hot to ensure an accurate check. The fluid level rises as temperature increases. 1. Operate the transmission in DRIVE (D) range until the normal operating temperature of 160_F (71_C) to 200_F (93_C) is reached. 2. Pull out the dipstick and wipe it with a clean rag or paper towel. 3. Push it back in all the way, wait three seconds and then pull it back out again. Repeat the check procedure to verify the reading. 4. Safe operating level is within the HOT RUN band on the dipstick. The width of the HOT RUN band represents approximately 1.06 quart (1.0 liter) of fluid at normal operating temperature. 5. If the fluid level is not within the HOT RUN band, add or drain fluid as necessary to bring the fluid level to within the HOT RUN band. 6. If the fluid level is in the acceptable range, push the dipstick back in all the way. Consistency of Readings Always check the fluid level at least twice using the procedures described previously. Consistency (repeatable readings) is important to maintaining proper fluid level. If inconsistent readings persist, check the transmission breather to be sure it is clean and unclogged. If readings are still inconsistent, contact your dealer. How to Add Fluid Refer to the Maintenance Schedule to determine what kind of transmission fluid to use. See "Recommended Fluids and Lubricants" in the Index. Add fluid only after checking the transmission fluid while it is hot. (A cold check is used only as a reference.) If the fluid level is low, add only enough of the proper fluid to bring the level up to the HOT area for a hot check. It doesn't take much fluid, generally less than one pint (0.5 L). Don't overfill. 6-28