2003 Chevrolet Astro Owner's Manual - Page 240

Reinstalling the Engine Cover 1. Lift the engine cover into the front of the vehicle and slide it all the way forward. Make sure the rubber seal is over the latches. 2. Tighten the two bolts located on the engine cover to reinstall the cover to the front of the dash. 3. Put the heaterduct over the engine cover studs. Push up onthe duct gently until it snaps into place. 4. Reconnect the electrical connectors. 5. Reconnect the AM radio ground strap. 8. Grasp the bottom of the cover and slide it rearward. Then, lift it up and out of the vehicle. If the seal does not release, use the pull strap on the driver's side above the rear mount. 6. Reinstall the engine cover extension by gently squeezing the sides and sliding it into place. Make sure all of the fastener clips engage and the extension fits properly in place. Reinstall and tighten the two screws. 7. Reinstall the two nuts to secure the extension in place. 5-23