Home » Chevrolet Manuals » 2003 Chevrolet Monte Carlo » Manual Viewer

2003 Chevrolet Monte Carlo Owner's Manual - Page 103

2003 Chevrolet Monte Carlo Manual

Get 2003 Chevrolet Monte Carlo PDF manuals and user guides

View all 2003 Chevrolet Monte Carlo manuals

Page 103 highlights

Be sure that people and objects are clear of the garage door or gate operator you are programming. When programming a garage door, it is advised to park outside of the garage. It is recommended that a new battery be installed in your hand-held transmitter for quicker and more accurate transmission of the radio frequency. Your vehicle's engine should be turned off while programming the transmitter. Follow these steps to program up to three channels: 3. Simultaneously press and hold both the desired button on HomeLink@ and hand-held transmitter the button. Do not release the buttons until Step 4 has been completed. Some entry gates and garage door openers may require you to substitute Step 3 with the procedure noted in "Gate Operator and Canadian Programming" later in this section. 4. The indicator light will flash slowly at first and then rapidly after HomeLink@ successfully receives the frequency signal from the hand-held transmitter. Release both buttons. 1. Press and hold down the two outside buttons, releasing only when the indicator light begins to flash, after 20 seconds. Do not hold down the buttons for longer than 30 seconds and do not repeat this step to program a second and/or third transmitter to the remaining two HomeLink@ buttons. 2. Position the end of your hand-held transmitter about 1 to 3 inches (3 to 8 cm) away from the HomeLink@ buttons while keeping the indicator light in view. 5. Press and hold the newly-trained HomeLink@ button and observe the indicator light. If the indicator light stays on constantly, programming is complete and your device should activate when the HomeLink@ buttonis pressed and released. To program the remaining two HomeLink@ buttons, begin with Step 2 under "Programming HomeLink@." Do not repeat Step 1 as this will erase all of the programmed channels. If the indicator light blinks rapidly for two seconds and then turns to a constant light, continue with Steps 6 through 8 following to complete the programming of a rolling-code equipped device (most commonly, a garage door opener). 2-38

Section	Page
Table of Contents	2
Seats and Restraint Systems	8
Front Seats	9
Manual Seats	9
Six-Way Power Seats	10
Manual Lumbar	10
Heated Seats	11
Reclining Seatbacks	11
Head Restraints	13
Seatback Latches	13
Easy Entry Seat	14
Rear Seats	15
Split Folding Rear Seat	15
Safety Belts	17
Safety Belts: They Are for Everyone	17
Questions and Answers About Safety Belts	21
How to Wear Safety Belts Properly	22
Driver Position	23
Safety Belt Use During Pregnancy	29
Right Front Passenger Position	30
Rear Seat Passengers	30
Rear Safety Belt Comfort Guides for Children and Small Adults	33
Safety Belt Extender	35
Child Restraints	36
Older Children	36
Infants and Young Children	38
Child Restraint Systems	42
Where to Put the Restraint	45
Top Strap	46
Top Strap Anchor Location	47
Lower Anchorages and Top Tethers for Children (LATCH System)	47
Securing a Child Restraint Designed for the LATCH System	49
Securing a Child Restraint in a Rear Seat Position	50
Securing a Child Restraint in the Right Front Seat Position	52
Air Bag Systems	55
Where Are the Air Bags?	57
When Should an Air Bag Inflate?	59
What Makes an Air Bag Inflate?	60
How Does an Air Bag Restrain?	60
What Will You See After an Air Bag Inflates?	61
Servicing Your Air Bag-Equipped Vehicle	63
Restraint System Check	64
Checking Your Restraint Systems	64
Replacing Restraint System Parts After a Crash	65
Features and Controls	66
Keys	67
Remote Keyless Entry System	69
Remote Keyless Entry System Operation	70
Doors and Locks	73
Door Locks	73
Power Door Locks	74
Programmable Automatic Door Locks	74
Lockout Protection	75
Leaving Your Vehicle	75
Trunk	76
Windows	78
Power Windows	79
Sun Visors	79
Theft-Deterrent Systems	80
Content Theft-Deterrent	80
Passlock	81
Starting and Operating Your Vehicle	82
New Vehicle Break-In	82
Ignition Positions	82
Starting Your Engine	83
Engine Coolant Heater	85
Automatic Transaxle Operation	86
Parking Brake	89
Shifting Into Park (P)	90
Shifting Out of Park (P)	92
Parking Over Things That Burn	92
Engine Exhaust	93
Running Your Engine While You Are Parked	94
Mirrors	95
Manual Rearview Mirror	95
Manual Rearview Mirror with OnStar	95
Automatic Dimming Rearview Mirror	96
Automatic Dimming Rearview Mirror with OnStar	96
Outside Power Mirrors	97
Outside Convex Mirror	98
Outside Heated Mirrors	98
OnStar	99
OnStar System	99
HomeLink Transmitter	102
Programming the HomeLink Transmitter	102
Storage Areas	106
Glove Box	106
Center Console Storage Area	106
Rear Storage Area	106
Convenience Net	106
Sunroof	107
Vehicle Personalization	108
Instrument Panel	116
Instrument Panel Overview	119
Hazard Warning Flashers	121
Other Warning Devices	121
Horn	122
Tilt Wheel	122
Turn Signal/Multifunction Lever	122
Exterior Lamps	129
Interior Lamps	131
Accessory Power Outlets	133
Auxiliary Power Connection (Power Drop)	134
Ashtrays and Cigarette Lighter	135
Climate Controls	136
Dual Climate Control System	136
Outlet Adjustment	139
Passenger Compartment Air Filter	140
Warning Lights, Gages and Indicators	141
Instrument Panel Cluster	142
Speedometer and Odometer	144
Tachometer	144
Safety Belt Reminder Light	144
Air Bag Readiness Light	145
Voltmeter Gage	146
Brake System Warning Light	146
Anti-Lock Brake System Warning Light	147
Traction Control System (TCS) Warning Light	148
Engine Coolant Temperature Gage	148
Malfunction Indicator Lamp	149
Oil Pressure Indicator Light	152
Cruise Control Light	153
Fuel Gage	154
Message Center	155
Service Traction System Warning Message	155
Traction Active Message	155
Battery Warning Message	156
Hot Coolant Temperature Warning Message	156
Low Oil Pressure Message	157
Low Engine Oil Level Message	157
Change Engine Oil Message	158
Low Tire Message	158
Door Ajar Warning Message	159
Trunk Ajar Warning Message	159
Security Message	160
Low Washer Fluid Warning Message	160
Low Fuel Warning Message	161
Low Brake Fluid Warning Message	161
Service Vehicle Soon Message	162
Highbeam Out Warning Message	162
Driver Information Center (DIC)	163
Trip Computer	166
Audio System(s)	167
Setting the Time	167
Radio with CD	168
Radio with Cassette and CD	177
Theft-Deterrent Feature (RDS Radios)	190
Audio Steering Wheel Controls	190
Understanding Radio Reception	191
Care of Your Cassette Tape Player	192
Care of Your CDs	193
Care of Your CD Player	193
Backglass Antenna	193
XM Satellite Radio Antenna System	194
DAB Radio Antenna System	194
Vehicle Customization Settings	194
Chime Level Adjustment	194
Driving Your Vehicle	196
Your Driving, the Road, and Your Vehicle	197
Defensive Driving	197
Drunken Driving	197
Control of a Vehicle	200
Braking	201
Traction Control System (TCS)	203
Steering	205
Off-Road Recovery	207
Passing	208
Loss of Control	209
Driving at Night	210
Driving in Rain and on Wet Roads	212
City Driving	215
Freeway Driving	216
Before Leaving on a Long Trip	217
Highway Hypnosis	218
Hill and Mountain Roads	219
Winter Driving	220
If You Are Stuck: In Sand, Mud, Ice or Snow	225
Towing	226
Towing Your Vehicle	226
Recreational Vehicle Towing	226
Loading Your Vehicle	227
Towing a Trailer	229
Service and Appearance Care	236
Service	238
Doing Your Own Service Work	239
Adding Equipment to the Outside of Your Vehicle	239
Fuel	240
Gasoline Octane	240
Gasoline Specifications	240
California Fuel	241
Additives	241
Fuels in Foreign Countries	242
Filling Your Tank	242
Filling a Portable Fuel Container	244
Checking Things Under the Hood	245
Hood Release	246
Engine Compartment Overview	247
Engine Oil	250
Engine Air Cleaner/Filter	257
Automatic Transaxle Fluid	258
Engine Coolant	260
Radiator Pressure Cap	263
Engine Overheating	263
Cooling System	266
Power Steering Fluid	276
Windshield Washer Fluid	277
Brakes	278
Battery	281
Jump Starting	282
Headlamp Aiming	288
Bulb Replacement	289
Halogen Bulbs	289
Headlamps, Front Turn Signal, Sidemarker, and Parking Lamps	289
Taillamps, Turn Signal, Stoplamps and Sidemarker Lamps	291
Back-up Lamps	292
Replacement Bulbs	292
Windshield Wiper Blade Replacement	293
Tires	294
Inflation -- Tire Pressure	295
Tire Pressure Monitor System	295
Tire Inspection and Rotation	297
When It Is Time for New Tires	298
Buying New Tires	299
Uniform Tire Quality Grading	300
Wheel Alignment and Tire Balance	301
Wheel Replacement	301
Tire Chains	302
If a Tire Goes Flat	303
Changing a Flat Tire	303
Compact Spare Tire	314
Appearance Care	316
Cleaning the Inside of Your Vehicle	316
Care of Safety Belts	319
Weatherstrips	319
Cleaning the Outside of Your Vehicle	319
Sheet Metal Damage	321
Finish Damage	321
Underbody Maintenance	322
Chemical Paint Spotting	322
GM Vehicle Care/Appearance Materials	322
Vehicle Identification	324
Vehicle Identification Number (VIN)	324
Service Parts Identification Label	324
Electrical System	325
Add-on Electrical Equipment	325
Headlamp Wiring	325
Windshield Wiper Fuses	325
Power Windows and Other Power Options	325
Fuses and Circuit Breakers	325
Capacities and Specifications	332
Normal Maintenance Replacement Parts	334
Maintenance Schedule	336
Maintenance Schedule	337
Introduction	337
Your Vehicle and the Environment	337
Maintenance Requirements	337
How This Section is Organized	338
Part A: Scheduled Maintenance Services	339
Using Your Maintenance Schedule	339
Scheduled Maintenance	339
Part B: Owner Checks and Services	344
At Each Fuel Fill	344
At Least Once a Month	344
At Least Twice a Year	345
At Least Once a Year	345
Part C: Periodic Maintenance Inspections	348
Steering, Suspension and Front Drive Axle Boot and Seal Inspection	348
Exhaust System Inspection	349
Fuel System Inspection	349
Engine Cooling System Inspection	349
Throttle System Inspection	349
Brake System Inspection	349
Part D: Recommended Fluids and Lubricants	350
Part E: Maintenance Record	351
Customer Assistance Information	354
Customer Assistance Information	355
Customer Satisfaction Procedure	355
Customer Assistance for Text Telephone (TTY) Users	356
Customer Assistance Offices	357
GM Mobility Program for Persons with Disabilities	358
Roadside Assistance Program	358
Courtesy Transportation	360
Reporting Safety Defects to the United States Government	361
Reporting Safety Defects to the Canadian Government	362
Reporting Safety Defects to General Motors	362
Service Publications Ordering Information	362

Match case Limit results 1 per page

Be sure that people and objects are clear of the garage

door or gate

operator you are programming. When

programming a

garage

door,

is advised to park outside

of the garage.

It is recommended that a

new battery be installed in

your hand-held transmitter for quicker and more

accurate transmission of the radio frequency.

Your

vehicle’s engine should be turned

off

while

programming the transmitter. Follow these steps to

program up

three channels:

Press and hold down the two outside buttons,

releasing only

when the indicator light begins to

flash, after

seconds.

not hold down the

buttons for longer than

seconds and do not

repeat this step

to program a second and/or third

transmitter to the remaining two HomeLink@ buttons.

Position the end of your hand-held transmitter about

inches

cm) away from the HomeLink@

buttons while keeping the indicator light in view.

Simultaneously press

and hold both the

desired

button on HomeLink@

and

the hand-held

transmitter

button.

not release

the

buttons

until

Step

has been completed.

Some entry gates and

garage

door

openers may

require you to substitute

Step

with

the

procedure

noted in “Gate

Operator

and

Canadian

Programming” later in this

section.

The indicator light

will

flash

slowly at

first

and

then

rapidly after

HomeLink@

successfully

receives

the

frequency signal from

the

hand-held

transmitter.

Release both buttons.

5. Press and hold the

newly-trained

HomeLink@

button

and observe the indicator

light.

If the indicator light

stays on constantly,

programming is complete and your

device

should

activate when

the

HomeLink@

button

is pressed

and

released.

To program the remaining

two

HomeLink@

buttons,

begin with Step 2 under

“Programming

HomeLink@.”

not repeat Step

as this will

erase

all of the

programmed channels.

the indicator light

blinks

rapidly

for

two

seconds

and then turns to

constant

light,

continue

with

Steps

through

following

complete

the

programming of a

rolling-code

equipped

device

(most commonly,

garage

door

opener).

2-38