2004 Chevrolet Malibu Owner's Manual - Page 125
2004 Chevrolet Malibu Manual
Page 125 highlights
Headlamp High/Low-Beam Changer To change the headlamps from low beam to high beam, push the turn signal/multifunction lever away from you. When the high beams are on, a light on the instrument panel cluster also will be on if the ignition is in ON. Windshield Wipers To change the headlamps from high beam to low beam, pull the turn signal lever toward you. Headlamps On Reminder If you open the driver's door and turn off the ignition while leaving the lamps on, you will hear a warning chime. Use this lever located on the right side of the steering wheel to operate the windshield wipers. 9(Off): Move the lever to this position to turn off the windshield wipers. & (Intermittent): Move the lever to this position to choose a delayed wiping cycle. Turn the intermittent adjust band down for a longer delay or up for a shorter delay. The wiper speed can only be manually adjusted when the lever is in this position. Move the lever to this position for speed sensitive operation. When you select this position, the delay will change with your vehicle's speed. The delay will decrease as you go faster and increase as you go slower. 3-9 Flash-to-Pass Feature This feature lets you use your high-beam headlamps momentarily to signal a driver in front of you that you want to pass. To use it, pull the turn signal/multifunction lever toward you until the high-beam headlamps come on, then release the lever to turn them off. & (Speed Sensitive Wipers):