2005 Chevrolet Aveo Owner's Manual - Page 202

How to Add Fluid Refer to the Maintenance Schedule to determine what kind of transaxle fluid to use. See Part D: Recommended Fluids and Lubricants on page 6-24. If the fluid level is low, add only enough of the proper fluid to bring the level into the area between the two dimples in the hot range on the dipstick. 1. Pull out the dipstick. 2. Using a long-neck funnel, add enough fluid at the dipstick hole to bring it to the proper level. It does not take much fluid, generally less than one pint (0.5 L). Do not overfill. Notice: Use of automatic transaxle fluid labeled other than T-IV Automatic Transaxle Fluid may damage your vehicle, and the damages may not be covered by your warranty. Always use T-IV labeled automatic transaxle fluid in your vehicle. See Part D: Recommended Fluids and Lubricants on page 6-24 for more information. 3. After adding fluid, recheck the fluid level as described under "How to Check," earlier in this section. 4. When the correct fluid level is obtained, push the dipstick back in all the way. Manual Transaxle Fluid It is not necessary to check the transaxle fluid level. A transaxle fluid leak is the only reason for fluid loss. If a leak occurs, take the vehicle to the dealership service department and have it repaired as soon as possible. See Part D: Recommended Fluids and Lubricants on page 6-24 for the proper fluid to use. Hydraulic Clutch There is one reservoir for both the brake and the hydraulic clutch fluid. See Brakes on page 5-33 for more information. The hydraulic clutch linkage in your vehicle is self-adjusting. The master cylinder reservoir is filled with hydraulic fluid. A fluid loss in this system could indicate a problem. Have the system inspected and repaired. When to Check and What to Use Refer to the Maintenance Schedule to determine how often you should check the fluid level in your master cylinder reservoir and for the proper fluid. 5-20