2007 Chevrolet Tahoe Owner's Manual - Page 193
2007 Chevrolet Tahoe Manual
Page 193 highlights
To return the cover to the retracted position, do the following: 1. Pull up on the cover handle to release the cover posts from the retaining sockets. 2. Let the cover move forward to the full retracted position. To remove the cover, from a regular wheelbase model, do the following: 1. Let the cover go all the way into the holder. 2. Then, grasping the driver's side cover end cap, push the cover end cap toward the passenger's side of the vehicle. 3. Swing the cover rearward and take it out of the vehicle. To put the cover in the vehicle, do the following: 1. Make sure the cover slot in the holder faces rearward with the round surface facing down. 2. Then, hold the cover at an angle and place the cover end cap into the slot in the passenger's side trim panel. 3. Move the other end of the cover forward and hold it next to the driver's side trim panel slot. 4. Press the end caps in, this will allow the cover to fit into the trim slot. 5. Lightly pull on the cover holder to make sure it is secure. On the extended wheelbase models there are two cover positions. The slots furthest forward allow the cover to be used if the third seat is removed or folded down. The cover can be installed and removed from either side. 193