2007 Chevrolet Tahoe Owner's Manual - Page 195

4. Lower the system until the middle rollers are lined up with lower guides. While holding in the release lever, push the system forward until all three sets of rollers are on the guides. 5. Release the lever and push the system until the locator pin reaches the locator hole. To adjust the system from the lower position to the upper position, do the following: 1. Squeeze and hold the release lever to retract the locator pin. 2. Pull the system back and lift until the middle rollers can be placed into the upper guides. 3. Push the system forward until the front rollers are lined up with the vertical curved guides. 4. Push down on the rear of the system and raise the front rollers up the vertical curved guides. 5. Push the system forward until all three sets of rollers are resting on the guides and release the lever to engage the locating pin into the hole. To utilize the cargo management system as a table feature, squeeze the release lever and pull the system towards you until the locator pin reaches the next hole. The system will extend out of the vehicle. The liftgate cannot be closed in this position. Do not operate the vehicle with liftgate open. The cargo management system can be removed from the vehicle. This procedure should be completed by two people. While squeezing the release lever, pull the system back until the rollers clear the guides. To reinstall the system, align the rollers to the guides, squeeze the release lever and push into position. 195