2007 Chevrolet Tahoe Owner's Manual - Page 208
2007 Chevrolet Tahoe Manual
Page 208 highlights
The windshield wipers are controlled by turning the band with the wiper symbol. Rainsense™ II Wipers If your vehicle has Rainsense™ II windshield wipers, the moisture sensor is located next to the inside rearview mirror and is mounted on the windshield. When active, these sensors are able to detect moisture on the windshield and automatically turn on the wipers. To turn on the Rainsense™ feature, the wipers must be set to one of the five delay settings on the multifunction lever. Each of the five settings adjusts the sensitivity of the rainsensor. Since different drivers have different setting preferences, it is recommended that the mid-range setting (position 3) be used initially. For more wipes, select the higher settings; for fewer wipes, select the lower settings located closer to the off position on the multifunction lever. 8 (Mist): Turn the band to mist for a single wiping cycle. Hold it there until the wipers start. Then let go. The wipers will stop after one wipe. Hold the band on mist longer, for more wipe cycles. 9 (Off): To stop the wipers, move the band to off. 6 (Delay): The wiper speed can be set for a long or short delay between wiping cycles. This can be very useful in light rain or snow. Turn the band to choose the delay time. The closer to the top of the lever, the shorter the delay. 6 (Low Speed): Turn the band away from you to the first solid band past the delay settings, for steady wiping at low speed. 1 (High Speed): Turn the band further, to the second solid band past the delay settings, for high-speed wiping. 208